To: "Jim Wharton" <jwharton@tentec.com>
Subject: Re: Enclosures
X-Attachments: H:\PIC Projects\D700 Interface\eps for panel.zip;

Jim:

	Nice to talk to you this morning.  I've attached a .ZIP file that contains 
the .EPS file for the front panel for this project.  I zipped it because it was 25 
MB unzipped (!!!) but only 96KB zipped.   I'm not terribly familiar with .EPS 
files so if something looks strange here, please let me know.  I created this in 
Adobe Photoshop and saved it at 2400 pixels per inch.  Again, let me know if 
there are any problems.

	To recap the other points this morning...  I asked about whether using 4 
screws in the bottom was going to result in an additional cost over the 
method that we had previously discussed.  By the way, I had previously 
asked what type of screws would be needed to hold the box together and you 
had said a #6 by 3/8 pan head screw.  Given the new design, the screws 
used appear to be smaller.  Are they a number #4?  I'm assuming here that 
the screws were not included in the original cost estimate.  If it turns out they 
were included, then I'm obviously less concerned about making sure I have 
some of the correct screws on hand.

	The second item was the location of the hole for the LED.  If it is 
possible, I'd like to have the center of this hole aligned with the center of the 
hole for the pushbutton.  Aside from this, the sample box looks absolutely 
wonderful.  I really like the additional weight that the box has relative to the 
plastic ones I've been using.  It is more likely to stay put!

	Finally, if it is at all possible to complete the order in time for the annual 
Digital Communications Conference on September 10, it would be a great 
help.

	I do understand that there are some setup charges (as we previously 
discussed) associated with doing the silkscreen for the front panel.  Feel free 
to change the credit card number I gave you a few weeks ago.  

	I can be reached at one of the following numbers:

716-679-0034  (home)
716-673-3869  (office)
716-400-1024  (cell)

	Thanks again,

John
